Fiberstore 11 Steps To Teach You How To Install X2 Transceiver

Before,I introduction some X2 transceiver products, but how you install the merchandise do you know, if you not understanding, keep to the steps, you will soon learn how to install x2 transceiver.Cisco x2 transceiver module can be a hot swappable products designed for 10Gbps applications.

Step 1 Utilizing a small flat-blade screwdriver, carefully pry the X2 transceiver port cover from the system module faceplate. Make use of the two arrows on the port cover as guides for inserting the screwdriver blade. Save the main harbour cover future use.

Step 2 Eliminate the new X2 transceiver module looking at the protective packaging.

Step three Look into the label about the X2 transceiver module body to verify you have the correct model for your network.

Step 4 Take away the dust plug from X2 transceiver module optical port and hang up it aside.

Step # 5 Slide the X2 transceiver into the transceiver socket around the system module front panel before the X2 transceiver EMI gasket flange makes experience of the machine module faceplate.

Step six Press firmly about the front of the X2 transceiver module with your thumb to totally seat the transceiver in the transceiver socket.

Step 7 Verify how the X2 transceiver is properly seated and latched inside the socket, by grasping the right and left sides (or the bottom and top) with the transceiver's EMI gasket flange with your thumb and forefinger and gently pulling around the transceiver. Usually do not pull on the latching sleeve since you will release the transceiver.

When the transceiver will not pull free, it is properly seated and latched.

When the transceiver does pull free, slide the X2 transceiver back into the socket and apply more pressure along with your thumb about the front from the transceiver. Do this again before the X2 transceiver is securely latched in the socket.

Step 8 Reinstall the dust plug to the transceiver's optical bore before you are ready to attach the network interface cable.

Step 9 If you're cabling an optical X2 transceiver module, follow these sub-steps. If you're cabling a CX4 X2 transceiver module, go to step 10.

a. Remove the dust plugs from the optical network interface cable SC connectors. Save the dust plugs for future use.
b. Inspect and clean the SC connector's fiber-optic end faces.
c. Remove the dust plugs from the X2 transceiver module optical bores.
d. Immediately attach the network interface cable SC connectors to the X2 transceiver module.

Step 10 Plug the InfiniBand cable connector into the CX4 X2 transceiver module connector. Make certain the InfiniBand cable connector is aligned with the X2 transceiver module.

Step 11 Carefully route the InfiniBand network cable through the cable management brackets on your own system. Figure 6 shows how the InfiniBand cable needs to be routed through either a horizontal cable management bracket or even a vertical cable management bracket.

This installation procedure pertains to both the spring-loaded and non-spring-loaded X2 transceiver modules. If you have every other questions,welcome to fiberstore.com .Fiberstore can be a fiber optic transceivers supplier ,and that we offer a number of X2 transceiver,including Cisco X2-10GB-SR,Cisco X2-10GB-LR,Cisco X2-10GB-ER,Cisco X2-10GB-ZR,Cisco X2-10GB-LRM and so on.We have been a professional supplier, your choice is our very best certainly.